Μηχανή συγκόλλησης άκρων

IMA NOVIMAT / CONTOUR / I / G80 / 790 / L20

Single-sided edge bander for narrow edges IMA NOVIMAT / CONTOUR / I / G80 / 790 / L20 with a servo corner copying unit MFA
Year of manufacture: 2009
Technical condition: very good

- Rigid machine base to which the individual processing units are mounted.
- Feed speed from 6–30 m/min, electronically controlled
(the speed of the processing units is not synchronized with the full feed speed adjustment range).
- Feed chain guided in sliding guides with plastic glide plates
and a rubber coating 80 mm wide.
- Automatic feed chain lubrication controlled by the machine program.
- Upper pressure unit made of a double V-belt, 70 mm wide, running on ball bearing guide rollers; electronically adjustable pressure.
- Machine safety in accordance with CE certification.
- Soundproof and safe enclosures.
- Edging unit drive installed in a tightly sealed oil bath with glue pot
(1 main powered pressure roller + 5 auxiliary rollers); pneumatic Quick-Lock glue pot clamping system enabling fast replacement.
- Touchscreen display.
- End trimming saw unit for trimming excess edge at the front and rear corners of the workpiece
with the following features: pneumatic saw adjustment from 0–25°, straight cuts and corner chamfering,
automatic saw setting for corner chamfering for two different edge thicknesses (e.g. 0.4 and 1.2 mm), and adjustment of edge overhang for corner copying.
- All processing units equipped with chip extraction ports.
- Novimat Contour series edge banders provide very high processing quality due to the powerful corner copying unit and the minimal gap between parts (~300 mm).

Main technical data:
- Edge material from roll thickness: 0.3–3 mm
Dsdpfx Aasw R S Slocowc
- Paper, PVC, and ABS edge: 0.3–3.0 mm
- Veneer: 0.5–3.0 mm
- Wood strips: 0.8–20 mm
- Edge height: 14–65 mm
- Maximum edge overhang from the top:
• For edge thickness up to 8 mm – 5 mm
• Above 8 mm – 2 mm

Workpiece dimensions:
- Minimum length in feed direction: 150 mm
- Minimum width (for elements up to 25 mm thick): 65 mm
- Minimum thickness: 8 mm (without flat scraper) or 12 mm (with flat scraper)
- Maximum thickness:
• without corner copying: max 60 mm
• with corner copying: max 40 mm
- Smallest part: 150 × 150 mm or 65 × 300 mm
(note: * 65 mm at a maximum thickness of 25 mm)

Machine technical parameters:
- Feed speed electronically controlled in the range: 6–30 m/min
(note: feed may be limited by specific units on the machine)
- Workpiece overhang from feed chain:
• 38 mm (including edge thickness 0.3–8 mm)
• 30 mm (including edge thickness 8.1–20 mm)

Power supply:
- Voltage: 400/230 V, +5/–10 % with neutral
- Frequency: 50 Hz
- Control voltage: 230 V AC / 24 V
- Compressed air: 8 bar
- Extraction air speed: 28 m/s

Η διαφήμιση μεταφράστηκε αυτόματα και ενδέχεται να περιέχει ορισμένα σφάλματα μετάφρασης.